I am trying to get some servos working and am not sure where I am going wrong.
I am using the Set Servo Angle Farmware which I am assuming sends a PWM signal to the pin defined in the Farmware config, in my case I am using pins 4 and 5. The sequence is as follows:
I tried hooking up a servo directly to the servo pins on the Farmduino and I get no love.
I even lugged my oscilloscope out to the Farmbot and found no signals coming from pins 4 and 5, but was reading about 6 volts on the power pins.
If anyone can suggest trying something, please do.