# Gen 7 tool connection

**URL:** <https://forum.farmbot.org/t/gen-7-tool-connection/10087>\
**Category:** Troubleshooting\
**Created:** [May 19, 2026, 11:36pm UTC](https://forum.farmbot.org/t/gen-7-tool-connection/10087 "2026-05-19T23:36:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![lsurowiec](https://forum.farmbot.org/letter_avatar_proxy/v4/letter/l/ecccb3/32.png) [@lsurowiec](https://forum.farmbot.org/u/lsurowiec)\
**Post date:** [May 19, 2026, 11:36pm UTC](https://forum.farmbot.org/t/gen-7-tool-connection/10087/1 "2026-05-19T23:36:49Z")

</div>

We are having an ongoing issue with our FarmBot tools not properly verifying or connecting through the UTM. The FarmBot recognizes the tool bay, but the tools themselves either fail verification or intermittently disconnect during operation.

We have already:

- Checked wiring and tool connections
- Restarted the FarmBot and FarmBot OS
- Re-seated the tools multiple times
- Confirmed magnets/connectors appear aligned
- Contacted support, but have not yet received a solution

Current symptoms include:

- Tool verification failing
- UTM not consistently detecting attached tools
- Jobs stopping because the tool is reported as disconnected

Has anyone else experienced this issue recently? If so:

- What ended up causing it?
- Was it hardware, firmware, calibration, or a connector issue?
- Are there any specific diagnostics we should run?

Any help or troubleshooting suggestions would be greatly appreciated. Thanks

---

<div class="post-metadata">

**Author:** ![system](https://forum.farmbot.org/user_avatar/forum.farmbot.org/system/32/4564_2.png) [@system](https://forum.farmbot.org/u/system)\
**Post date:** [June 2, 2026, 11:37pm UTC](https://forum.farmbot.org/t/gen-7-tool-connection/10087/2 "2026-06-02T23:37:27Z")

</div>

Closed on June 2, 2026, 11:37pm UTC

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.
