Farmduino conector and UTM cable don´t match

1

Hello to all, I’m checking why my farmbot doesn’t work. It doen’t detect the different tools. I am checking with my multimeter and I noticed that the cables color code matches (the red is the A, black the B) but when I measured the pin out of the farmduino it doesn’t match the values of the position of the cables. Does someone have the pin out of the farmduino?

2

my board loks like this one Farmduino | FarmBot Genesis Documentation and I jumpered wire the, top pins from: A top to I, B top to J, and C top to K. May be that is the problem.

3

@pollo

Hello Carlos,

Please review this page on UTM troubleshooting and Tool Verification:

Please review this page on UTM troubleshooting and tool verification:

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.