Hi everyone hope you’re doing fine in those troubled times…
Our Z location resets to 0 after every move.
Did this ever happen to someone!?
All the best from France
Coline and the kids
Hi everyone hope you’re doing fine in those troubled times…
Our Z location resets to 0 after every move.
Did this ever happen to someone!?
All the best from France
Coline and the kids
You may be having some encoder problems on your Z-Axis motor.
Also, you may need to check the intermediate connector where the Z-Axis encoder wire from the motor mates up with the Z-Axis encoder wire going to the electronics box. Sometimes if the intermediate connector is loose, it can disrupt the encoder signal going to your Farmduino electronics.
Please review this page:
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.