Motor settings for up/down movement on z-axis to reduce noise/vibrations

[eide]

I posted the guide for replacement here:

Stepper driver change for no-noise bot

In case anyone needs this as well, sharing a guide how to replace stock drivers with TMC2208. I haven’t tested them long enough, but they are absolutely quiet, which is cool and that makes a lot of difference So some good resources to go to: video how to replace old drivers with TMC2208, most important takeaway - pay attention to their orientation - i.e. make sure DIR and GND pins get to same pins as with previous drivers. Replace when farmbot is powered off. […

And recently I had issues with microstepping - I have reported it to the forum but can’t find topic anymore. however - these settings work for me now (please note that I have TMC2208 only on X and Y axis right now, so you should ignore Z axis settings in your case (I have no explanation why these settings work for X and Y axis with 1/2 microstepping, in my opinion they should not - but they do )